我的无线网卡驱动问题，向高人求助

tq0fqeu · 发表于 2007-12-30 22:48:00

我的无线网卡是bcm94311mcg
搜索了网上的一些方法，例如用ndiswrapper的方法。但是对于bcm94311mcg似乎不支持
以前在ubuntu下都是系统安好的。可不可以把ubuntu的驱动安装上。
望高人指导，在线等结果。

youngtrips · 发表于 2007-12-30 23:52:41

我的也是bcm的，在f6下也没法驱动，用ndiswrapper也没用，请高人帮帮忙阿，谢谢啦。

tq0fqeu · 发表于 2007-12-31 11:56:45

# iwconfig
lo       no wireless extensions.

eth0    no wireless extensions.

wmaster0  no wireless extensions.

wlan0    IEEE 802.11g  ESSID:""
      Mode:Managed  Channel:0  Access Point: Not-Associated
      Tx-Power=0 dBm
      Retry min limit:7 RTS thr

ff Fragment thr=2346 B
Encryption key

ff
      Link Quality:0  Signal level:0  Noise level:0
      Rx invalid nwid:0  Rx invalid crypt:0  Rx invalid frag:0
      Tx excessive retries:0  Invalid misc:0 Missed beacon:0
iwlist scan
lo       Interface doesn't support scanning.

eth0    Interface doesn't support scanning.

wmaster0  Interface doesn't support scanning.

wlan0    Interface doesn't support scanning : Network is down
01:00.0 Network controller: Broadcom Corporation BCM94311MCG wlan mini-PCI (rev 01)
      Subsystem: Hewlett-Packard Company Unknown device 1364
      Flags: bus master, fast devsel, latency 0, IRQ 19
      Memory at b3000000 (32-bit, non-prefetchable) [size=16K]
      Capabilities: [40] Power Management version 2
      Capabilities: [58] Message Signalled Interrupts: Mask- 64bit- Queue=0/0 Enable-
      Capabilities: [d0] Express Legacy Endpoint IRQ 0
01:00.0 0280: 14e4:4311 (rev 01)
      Subsystem: 103c:1364
      Flags: bus master, fast devsel, latency 0, IRQ 19
      Memory at b3000000 (32-bit, non-prefetchable) [size=16K]
      Capabilities: [40] Power Management version 2
      Capabilities: [58] Message Signalled Interrupts: Mask- 64bit- Queue=0/0 Enable-
      Capabilities: [d0] Express Legacy Endpoint IRQ 0

tq0fqeu · 发表于 2007-12-31 11:58:49

b43-phy0: Broadcom 4311 WLAN found
ACPI: AC Adapter [ADP1] (on-line)
b43-phy0 debug: Found PHY: Analog 4, Type 2, Revision 8
b43-phy0 debug: Found Radio: Manuf 0x17F, Version 0x2050, Revision 2
phy0: Selected rate control algorithm 'simple'

joint · 发表于 2007-12-31 12:41:40

搜索一下 b43-fwcutter

藕节 · 发表于 2008-1-1 01:56:35

难道无线网卡没起来？

wlan0 Interface doesn't support scanning : Network is down

#ifconfig wlan0 up
#iwlist wlan0 scanning

藕节 · 发表于 2008-1-1 02:00:45

Post by youngtrips;1801572
我的也是bcm的，在f6下也没法驱动，用ndiswrapper也没用，请高人帮帮忙阿，谢谢啦。

一般情况下ndiswrapper都能解决驱动的问题。
若lspci的输出显示已正确识别出设备，差不多就说明驱动装好了，剩下的就不是驱动问题了。

youngtrips · 发表于 2008-1-1 06:59:34

用lspci可以显示无线网卡。用了很多方法都没法驱动起来。

		自动登录	找回密码
密码			注册