那位好兄帮帮忙，一个关于Mandrake9.0下上网的问题？

yushuanglin

从硬盘安转Mdk9.0，设置网络好长时间也没有设置好。上网方式：
3c509B网卡——HUB—— 电信——internet
在win2000下用PPP0E拨号上网

coolfires

这个嘛~~ MDK9.0 本身就自带的呢  
硬件控制中心-》网络-》连接-》
然后就按“向导”键，自动检测 有一点的是你要选择ADSL 和 pppo
协议就行拉,还有是用户和密码 其它可以留空~~~~~~~~

faint

Mandrake linux下的上网很容易配置的。

jeffereylj

it is not an easy problem,  If you want use Mandrake Contral Center to solve the problem. I could tell you that you are definitely wrong, because mandrake linux 9.0 has a serious problem with an ethernet card in a mother board. If your ethernet is in your motherboard, I could offer you a solution. Try this. At the lilo screen, press the Esc key to get to a text prompt, then type linux noapic. If you are in the screen where you can find boot:, you are in the right place. Here type you LILO NOAPIC.  and see if networking works properly when it finished booting. (you may have to config it). If you have to config it, youl need to replace quiet with noapic in the append section of lilo.conf. run /sbin/lilo to save the change. and reboot the system.MAN, you are very lucky if you succeed with my help. YOU ARE SHARING MY VALUABLE EXPERIENCE. I HAVE SPENT 20 DAYS ON SUCH A '?07ASY' PROBLEM. GOOD LUCK.

yushuanglin

还是不能配置好，配置过程：硬件控制中心-》网络-》连接-》 ->>向导，自动检测 ,选择ADSL 和 pppoe 。配置n次，只有一次连上网，logout又不能连上。通过查看发现系统把网卡配置为100
，但windowers下为3com etherLink 10/100 pci tx nic (3c905b-tx).

faint

1）如果你的安全级别设得过高，有可能上不了网，把级别降低。
2)firewall装上没有？装了的话，把你想开的去掉。
3)

1. more /etc/sysconfig/network
   
2. NETWORKING=yes
   
3. FORWARD_IPV4=false
   
4. HOSTNAME=faint.mdk.org
   
5. DOMAINNAME=mdk.org
   
6. GATEWAY=""
   
7. GATEWAYDEV=""
   

复制代码

你可以能者下，注意后面GATEWAY和GATEWAYDEV留空。因为你是能过pppoe上网的。因为你通过drakconf来配置的话，gateway是必须填上的。。。。

这类帖子以前有过讨论，细心找下。

如果不行，请把你的route的结果给出。。。。。。