我这是什么错误阿

anuode

第一次玩嵌入式,用的skyeye来引导u-boot,但是怎么也起不来,我的 作法是万全按照这篇文章做的:
http://skyeye.sourceforge.net/wiki/SkyeyeUboot

按理说最后应该 可以 看见u-boot的提示符,但是我只能得到错误的结果:

[root@anuode board01]# skyeye
***************************************************************
****                                                       ****
****   SkyEye  Simulator Ver 0.8.5 with  GDB 5.3 Interface ****
****                                                       ****
***************************************************************
GNU gdb 5.3
Copyright 2002 Free Software Foundation, Inc.
GDB is free software, covered by the GNU General Public License, and you are
welcome to change it and/or distribute copies of it under certain conditions.
Type "show copying" to see the conditions.
There is absolutely no warranty for GDB.  Type "show warranty" for details.
This SkyEye was configured as "--host=i686-pc-linux-gnu --target=arm-elf".
(SkyEye) tar s
cpu info: armv4, arm720t, 41807200, ffffff00, 1
mach info: name ep7312, mach_init addr 0x8141624
SKYEYE: use arm7100 mmu ops
Loaded ROM u-boot.bin
Connected to the simulator.
(SkyEye) r
Starting program:
warning: No executable file specified.
warning: No program loaded.


U-Boot 1.1.4 (Mar 14 2006 - 16:57:57)

U-Boot code: C0F80000 -> C0F952BC  BSS: -> C0F997EC
RAM Configuration:
Bank #0: c0000000 16 MB
Flash: 16 MB
*** Warning - bad CRC, using default environment

In:    serial
Out:   serial
Err:   serial
Hit any key to stop autoboot:  0
CS8900 Ethernet chip not found?!
BOOTP broadcast 1
sim_info called

Program received signal SIGINT, Interrupt.
No program loaded.
0xc0f8087c in ?? ()
(SkyEye)

请大虾赐教阿