|
- Jun 13 07:00:07 Looks syslog-ng[4837]: STATS: dropped 0
- Jun 13 08:00:07 Looks syslog-ng[4837]: STATS: dropped 0
- Jun 13 09:00:07 Looks syslog-ng[4837]: STATS: dropped 0
- Jun 13 10:00:07 Looks syslog-ng[4837]: STATS: dropped 0
- Jun 13 11:00:07 Looks syslog-ng[4837]: STATS: dropped 0
- Jun 13 11:05:33 Looks init: Switching to runlevel: 0
- Jun 13 11:05:35 Looks sshd[4968]: Received signal 15; terminating.
- Jun 13 11:05:36 Looks kernel: Kernel logging (proc) stopped.
- Jun 13 11:05:36 Looks kernel: Kernel log daemon terminating.
- Jun 13 11:05:37 Looks syslog-ng[4837]: syslog-ng version 1.6.8 going down
- Jun 13 11:07:41 Looks syslog-ng[4852]: syslog-ng version 1.6.8 starting
- Jun 13 11:07:42 Looks sshd[4989]: Server listening on :: port 22.
- Jun 13 11:07:43 Looks /usr/sbin/cron[5155]: (CRON) STARTUP (V5.0)
- Jun 13 11:07:44 Looks rcpowersaved: CPU frequency scaling is not supported by your processor.
- Jun 13 11:07:44 Looks rcpowersaved: enter 'CPUFREQD_MODULE=off' in /etc/sysconfig/powersave/cpufreq to avoid this warning.
- Jun 13 11:07:44 Looks rcpowersaved: Cannot load cpufreq governors - No cpufreq driver available
- Jun 13 11:07:44 Looks syslog-ng[4852]: Changing permissions on special file /dev/xconsole
- Jun 13 11:07:44 Looks syslog-ng[4852]: Changing permissions on special file /dev/tty10
- Jun 13 11:07:44 Looks ifup: No configuration found for sit0
- Jun 13 11:07:44 Looks SuSEfirewall2: Warning: ip6tables does not support state matching. Extended IPv6 support disabled.
- Jun 13 11:07:44 Looks SuSEfirewall2: Setting up rules from /etc/sysconfig/SuSEfirewall2 ...
- Jun 13 11:07:44 Looks [powersave]: ERROR (CPUFreq_Userspace:42) Could not set userspace governor, seems as if the cpufreq_use
- rspace module is not loaded.
- Jun 13 11:07:44 Looks [powersave]: ERROR (read_line:43) Could not open file for reading: '/sys/devices/system/cpu/cpu0/cpufre
- q/scaling_available_frequencies'
- Jun 13 11:07:44 Looks [powersave]: ERROR (read_line:43) Could not open file for reading: '/sys/devices/system/cpu/cpu0/cpufre
- q/scaling_min_freq'
- Jun 13 11:07:44 Looks [powersave]: ERROR (read_value:82) Could not read value in file /sys/devices/system/cpu/cpu0/cpufreq/sc
- aling_min_freq: error: No such file or directory!
- Jun 13 11:07:44 Looks [powersave]: ERROR (read_line:43) Could not open file for reading: '/sys/devices/system/cpu/cpu0/cpufre
- q/scaling_max_freq'
- Jun 13 11:07:44 Looks [powersave]: ERROR (read_value:82) Could not read value in file /sys/devices/system/cpu/cpu0/cpufreq/sc
- aling_max_freq: error: No such file or directory!
- Jun 13 11:07:44 Looks [powersave]: WARNING (getMinMaxSpeeds:349) Speedstepping not supported! Was the correct cpufreq module
- loaded?
- Jun 13 11:07:44 Looks [powersave]: WARNING (initFreqsViaTesting:377) Could not read min and max speed
- Jun 13 11:07:44 Looks [powersave]: ERROR (PM_Interface:231) Cannot create cpufreq objects
- Jun 13 11:07:44 Looks SuSEfirewall2: batch committing...
- Jun 13 11:07:44 Looks ifup: No configuration found for eth1
- Jun 13 11:07:44 Looks SuSEfirewall2: Firewall rules successfully set
- Jun 13 11:07:46 Looks kernel: klogd 1.4.1, log source = /proc/kmsg started.
- Jun 13 11:07:46 Looks kernel: parport: PnPBIOS parport detected.
- Jun 13 11:07:46 Looks kernel: parport0: PC-style at 0x378 (0x778), irq 7, dma 3 [PCSPP,TRISTATE,COMPAT,EPP,ECP,DMA]
- Jun 13 11:07:46 Looks kernel: lp0: using parport0 (interrupt-driven).
- Jun 13 11:07:46 Looks kernel: NET: Registered protocol family 10
- Jun 13 11:07:46 Looks kernel: Disabled Privacy Extensions on device c03bb0a0(lo)
- Jun 13 11:07:46 Looks kernel: IPv6 over IPv4 tunneling driver
- Jun 13 11:07:46 Looks kernel: ip6_tables: (C) 2000-2002 Netfilter core team
- Jun 13 11:07:46 Looks kernel: ip_tables: (C) 2000-2002 Netfilter core team
- Jun 13 11:07:46 Looks kernel: ip_conntrack version 2.1 (8192 buckets, 65536 max) - 248 bytes per conntrack
- Jun 13 11:07:46 Looks kernel: pci_hotplug: PCI Hot Plug PCI Core version: 0.5
- Jun 13 11:07:46 Looks kernel: usbcore: registered new driver usbfs
- Jun 13 11:07:46 Looks kernel: usbcore: registered new driver hub
- Jun 13 11:07:46 Looks kernel: ACPI-0212: *** Warning: Device is not power manageable
- Jun 13 11:07:46 Looks kernel: ACPI: PCI Interrupt 0000:00:1d.7[D] -> GSI 23 (level, low) -> IRQ 201
- Jun 13 11:07:46 Looks kernel: PCI: Setting latency timer of device 0000:00:1d.7 to 64
- Jun 13 11:07:46 Looks kernel: ehci_hcd 0000:00:1d.7: EHCI Host Controller
- Jun 13 11:07:46 Looks kernel: ehci_hcd 0000:00:1d.7: debug port 1
- Jun 13 11:07:46 Looks kernel: ehci_hcd 0000:00:1d.7: new USB bus registered, assigned bus number 1
- Jun 13 11:07:46 Looks kernel: ehci_hcd 0000:00:1d.7: irq 201, io mem 0xfebffc00
- Jun 13 11:07:46 Looks kernel: PCI: cache line size of 128 is not supported by device 0000:00:1d.7
- Jun 13 11:07:46 Looks kernel: ehci_hcd 0000:00:1d.7: USB 2.0 initialized, EHCI 1.00, driver 10 Dec 2004
- Jun 13 11:07:46 Looks kernel: hub 1-0:1.0: USB hub found
- Jun 13 11:07:46 Looks kernel: hub 1-0:1.0: 4 ports detected
- Jun 13 11:07:46 Looks kernel: USB Universal Host Controller Interface driver v2.3
- Jun 13 11:07:46 Looks kernel: ACPI: PCI Interrupt 0000:00:1d.0[A] -> GSI 16 (level, low) -> IRQ 169
- Jun 13 11:07:46 Looks kernel: PCI: Setting latency timer of device 0000:00:1d.0 to 64
- Jun 13 11:07:46 Looks kernel: uhci_hcd 0000:00:1d.0: UHCI Host Controller
- Jun 13 11:07:46 Looks kernel: shpchp: shpc_init : shpc_cap_offset == 0
- Jun 13 11:07:46 Looks kernel: uhci_hcd 0000:00:1d.0: new USB bus registered, assigned bus number 2
- Jun 13 11:07:46 Looks kernel: uhci_hcd 0000:00:1d.0: irq 169, io base 0x0000e800
- Jun 13 11:07:46 Looks kernel: hub 2-0:1.0: USB hub found
- Jun 13 11:07:46 Looks kernel: hub 2-0:1.0: 2 ports detected
- Jun 13 11:07:46 Looks kernel: ACPI: PCI Interrupt 0000:00:1d.1[b] -> GSI 19 (level, low) -> IRQ 209
- Jun 13 11:07:46 Looks kernel: PCI: Setting latency timer of device 0000:00:1d.1 to 64
- Jun 13 11:07:46 Looks kernel: uhci_hcd 0000:00:1d.1: UHCI Host Controller
- Jun 13 11:07:46 Looks kernel: uhci_hcd 0000:00:1d.1: new USB bus registered, assigned bus number 3
- Jun 13 11:07:46 Looks kernel: uhci_hcd 0000:00:1d.1: irq 209, io base 0x0000ec00
- Jun 13 11:07:46 Looks kernel: hub 3-0:1.0: USB hub found
- Jun 13 11:07:46 Looks kernel: hub 3-0:1.0: 2 ports detected
- Jun 13 11:07:46 Looks kernel: shpchp: shpc_init : shpc_cap_offset == 0
- Jun 13 11:07:46 Looks kernel: shpchp: shpc_init : shpc_cap_offset == 0
- Jun 13 11:07:46 Looks kernel: shpchp: shpc_init : shpc_cap_offset == 0
- Jun 13 11:07:46 Looks kernel: shpchp: Standard Hot Plug PCI Controller Driver version: 0.4
- Jun 13 11:07:46 Looks kernel: hw_random: RNG not detected
- Jun 13 11:07:46 Looks kernel: i8xx TCO timer: initialized (0x0460). heartbeat=30 sec (nowayout=0)
- Jun 13 11:07:46 Looks kernel: Intel(R) PRO/1000 Network Driver - version 6.0.60-k2-NAPI
- Jun 13 11:07:46 Looks kernel: Copyright (c) 1999-2005 Intel Corporation.
- Jun 13 11:07:46 Looks kernel: ACPI: PCI Interrupt 0000:05:01.0[A] -> GSI 74 (level, low) -> IRQ 217
- Jun 13 11:07:46 Looks kernel: e1000: eth0: e1000_probe: Intel(R) PRO/1000 Network Connection
- Jun 13 11:07:46 Looks kernel: ACPI: PCI Interrupt 0000:05:02.0[A] -> GSI 75 (level, low) -> IRQ 225
- Jun 13 11:07:46 Looks kernel: e1000: eth1: e1000_probe: Intel(R) PRO/1000 Network Connection
- Jun 13 11:07:46 Looks kernel: hda: ATAPI 24X CD-ROM drive, 128kB Cache, UDMA(33)
- Jun 13 11:07:46 Looks kernel: Uniform CD-ROM driver Revision: 3.20
- Jun 13 11:07:46 Looks kernel: hda: packet command error: status=0x51 { DriveReady SeekComplete Error }
- Jun 13 11:07:46 Looks kernel: hda: packet command error: error=0x54 { AbortedCommand LastFailedSense=0x05 }
- Jun 13 11:07:46 Looks kernel: ide: failed opcode was: unknown
- Jun 13 11:07:47 Looks kernel: e1000: eth0: e1000_watchdog_task: NIC Link is Up 100 Mbps Full Duplex
- Jun 13 11:07:47 Looks kernel: ACPI: Power Button (FF) [PWRF]
- Jun 13 11:07:47 Looks kernel: ACPI: Power Button (CM) [PWRB]
- Jun 13 11:07:47 Looks kernel: ACPI: Sleep Button (CM) [SLPB]
- Jun 13 11:07:47 Looks kernel: BIOS EDD facility v0.16 2004-Jun-25, 2 devices found
- Jun 13 11:07:47 Looks kernel: powernow: This module only works with AMD K7 CPUs
- Jun 13 11:07:52 Looks kernel: eth0: no IPv6 routers present
复制代码
貌似和CPU还有电源的问题,请熟悉的朋友帮忙分析一下呗~
感谢。 |
|