|
|
发表于 2004-12-17 20:11:47
|
显示全部楼层
最初由 零凌兴歆 发表
ok,If I turn to the root user and create the file
then turn back to the general user mode
May I SEE the win's FS in the general user mode?
You need to edit your filesystem table, i.e. /etc/fstab to define the block device, mount point and mount options so that your normal user can mount the windoze partition.
However, pay special attention. If you windoze is NTFS, then your should install captive to obtain full read/write access. Otherwise, you should mount it read only.
If it is FAT32, then no problems. |
|