［求助］编译内核时网卡 BCM5906M对应的模块是哪个，谁能帮忙看看？resovled

lovely_sunday

在debian编译内核2.6.24时找不到对应的网卡类型，


#lspci |grep Ethernet

06:00.0 Ethernet controller: Broadcom Corporation NetLink BCM5906M Fast Ethernet PCI Express (rev 02)


在ethernet (10 or 100Mbit) 里面要选那项呢？如果没有对应的网卡模块该怎样选呢，谢谢！！！！！





下面是那些选项：(不是2.6.24的配置选项，但大体上差不太多吧）

  

Ethernet (10 or 100Mbit)
   <*> Generic Media Independent Interface device support
   <M> Sun Happy Meal 10/100baseT support   
   <M> Sun GEM support
   

3COM cards
   
   <M> 3cr990 series "Typhoon" support
   <M> AMD LANCE and PCnet (AT1500 and NE2100) support
   

Western Digital/SMC cards
   
   [] Racal-Interlan (Micom) NI cards
     
   Tulip family network device support --->
   < > AT1700/1720/RE1000Plus(C-Bus) support (EXPERIMENTAL)
   <> DEPCA, DE10x, DE200, DE201, DE202, DE422 support
   <> HP 10/100VG PCLAN (ISA, EISA, PCI) support
   [ ] Other ISA cards
   <M>Cabletron E21xx support
   <M> EtherWORKS 3 (DE203, DE204, DE205) support
   <M> EtherExpress 16 support
   <M> EtherExpressPro support/EtherExpress 10 (i82595) support
   <M> HP PCLAN+ (27247B and 27252A) support
   <M> HP PCLAN (27245 and other 27xxx series) support
   <M> LP486E on board Ethernet
   <M> ICL EtherTeam 16i/32 support
   <M> NE2000/NE1000 support
   <M> Zenith Z-Note support (EXPERIMENTAL)
   <M> SEEQ8005 support (EXPERIMENTAL)
   

EISA, VLB, PCI and on board controllers
     <> AMD PCnet32 PCI support
     <> AMD 8111 (new PCI lance) support
   

   Enable NAPI support                        
   <> Adaptec Starfire/DuraLAN support
     

   Use Rx Polling (NAPI)(EXPERIMENTAL)
   <> Ansel Communications EISA 3200 suppor(EXPERIMENTAL)
   <> Apricot Xen-II on board Ethernet
   <M> Broadcom 4400 ethernet support (EXPERIMENTAL)
   <> Reverse Engineered nForce Ethernet support (EXPERIMENTAL)
   <> CS89x0 support
   <> Digi Intl. RightSwitch SE-X support
   <> EtherExpressPro/100 support (eepro100, original Becker driver)
     

Use PIO instead of MMIO
   <> Intel(R) PRO/100+ support
   

   Use Rx Polling (NAPI)
   <> Myson MTD-8xx PCI Ethernet support
   <> National Semiconductor DP8381x series PCI Ethernet support
   <> PCI NE2000 and clones support (see help)
   <*> RealTek RTL-8139 C+ PCI Fast Ethernet Adapter support (EXPERIME )
   <*> RealTek RTL-8139 PCI Fast Ethernet Adapter support
   []   Use PIO instead of MMIO
   []   Support for uncommon RTL-8139 rev. K (automatic channel equal
   []   Support for older RTL-8129/8130 boards
   []   Use older RX-reset method                    
   <> SiS 900/7016 PCI Fast Ethernet Adapter support
   <> SMC EtherPower II
   <M> Sundance Alta support
   

   Use MMIO instead of PIO
   <> TI ThunderLAN support
   <> VIA Rhine support
        

   Use MMIO instead of PIO
   

Pocket and portable adapters

fei

tg3-------------

lovely_sunday

谢谢版主哦，
在选择驱动时我一个个的看了各个驱动的模块名称，没有叫tg3的模块，只好把可疑的驱动都编成模块，启动时就找到网卡驱动模块了

lovely_sunday

网络没有学好，
原来tg3 在这  Ethernet (1000 Mbit)
                       Broadcom Tigon3 support
看来还要补补网络的知识