网卡识别问题

opig

我把做好的LFS系统，移到一台工控机上，工控机一个4个网卡，e1000的。以前在RH9上，对应的很好，eth0-4.
但是换了LFS以后，顺序都乱了。变成了eth2-5，这个是为什么？应该真么调整，谢谢

显示如下：
root:~# ip addr sh
1: eth3: <NO-CARRIER,BROADCAST,MULTICAST,UP> mtu 1500 qdisc pfifo_fast qlen 100
    link/ether 00:90:0b:09:d7:a4 brd ff:ff:ff:ff:ff:ff
    inet 192.168.8.152/24 brd 192.168.100.255 scope global eth3
2: eth2: <BROADCAST,MULTICAST,UP,10000> mtu 1500 qdisc pfifo_fast qlen 100
    link/ether 00:90:0b:09:d7:a5 brd ff:ff:ff:ff:ff:ff
    inet 192.168.100.152/24 brd 192.168.100.255 scope global eth2
3: eth5: <NO-CARRIER,BROADCAST,MULTICAST,UP> mtu 1500 qdisc pfifo_fast qlen 100
    link/ether 00:90:0b:09:d7:a6 brd ff:ff:ff:ff:ff:ff
    inet 192.168.6.152/24 brd 192.168.100.255 scope global eth5
4: eth4: <NO-CARRIER,BROADCAST,MULTICAST,UP> mtu 1500 qdisc pfifo_fast qlen 100
    link/ether 00:90:0b:09:d7:a7 brd ff:ff:ff:ff:ff:ff
    inet 192.168.7.152/24 brd 192.168.100.255 scope global eth4
5: lo: <LOOPBACK,UP,10000> mtu 16436 qdisc noqueue
    link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
    inet 127.0.0.1/8 scope host lo
6: dummy0: <BROADCAST,NOARP> mtu 1500 qdisc noop
    link/ether 32:89:6c:26:3e:fc brd ff:ff:ff:ff:ff:ff

tfkdmwmqtr

看 LFS 手册后面部分，做规则文件。

byjxy

LFS手册上有,7.13.1. Creating stable names for network interfaces