rTorrent 的配置文件谁能帮忙解释一下!?

ssbeonly

[PHP]1         # This is an example resource file for rTorrent. Copy to
2         # ~/.rtorrent.rc and enable/modify the options as needed. Remember to
3         # uncomment the options you wish to enable.
4        
5         # Maximum and minimum number of peers to connect to per torrent.
6         #min_peers = 40   
7         #max_peers = 100  
8        
9         # Same as above but for seeding completed torrents (-1 = same as downloading)
10         #min_peers_seed = 10
11         #max_peers_seed = 50
12        
13         # Maximum number of simultanious uploads per torrent.
14         #max_uploads = 15
15        
16         # Global upload and download rate in KiB. "0" for unlimited.
17         #download_rate = 0
18         #upload_rate = 0
19        
20         # Default directory to save the downloaded torrents.
21         #directory = ./
22        
23         # Default session directory. Make sure you don't run multiple instance
24         # of rtorrent using the same session directory. Perhaps using a
25         # relative path?
26         #session = ./session
27        
28         # Watch a directory for new torrents, and stop those that have been
29         # deleted.
30         #schedule = watch_directory,5,5,load_start=./watch/*.torrent
31         #schedule = untied_directory,5,5,stop_untied=
32        
33         # Close torrents when diskspace is low.
34         #schedule = low_diskspace,5,60,close_low_diskspace=100M
35        
36         # Stop torrents when reaching upload ratio in percent,
37         # when also reaching total upload in bytes, or when
38         # reaching final upload ratio in percent.
39         # example: stop at ratio 2.0 with at least 200 MB uploaded, or else ratio 20.0
40         #schedule = ratio,60,60,stop_on_ratio=200,200M,2000
41        
42         # The ip address reported to the tracker.
43         #ip = 127.0.0.1
44         #ip = rakshasa.no
45        
46         # The ip address the listening socket and outgoing connections is
47         # bound to.
48         #bind = 127.0.0.1
49         #bind = rakshasa.no
50        
51         # Port range to use for listening.
52         #port_range = 6890-6999
53        
54         # Start opening ports at a random position within the port range.
55         #port_random = no
56        
57         # Check hash for finished torrents. Might be usefull until the bug is
58         # fixed that causes lack of diskspace not to be properly reported.
59         #check_hash = no
60        
61         # Set whetever the client should try to connect to UDP trackers.
62         #use_udp_trackers = yes
63        
64         # Alternative calls to bind and ip that should handle dynamic ip's.
65         #schedule = ip_tick,0,1800,ip=rakshasa
66         #schedule = bind_tick,0,1800,bind=rakshasa
67        
68         # Encryption options, set to none (default) or any combination of the following:
69         # allow_incoming, try_outgoing, require, require_RC4, enable_retry, prefer_plaintext
70         #
71         # The example value allows incoming encrypted connections, starts unencrypted
72         # outgoing connections but retries with encryption if they fail, preferring
73         # plaintext to RC4 encryption after the encrypted handshake
74         #
75         # encryption = allow_incoming,enable_retry,prefer_plaintext
76        
77         #
78         # Do not modify the following parameters unless you know what you're doing.
79         #
80        
81         # Hash read-ahead controls how many MB to request the kernel to read
82         # ahead. If the value is too low the disk may not be fully utilized,
83         # while if too high the kernel might not be able to keep the read
84         # pages in memory thus end up trashing.
85         #hash_read_ahead = 10
86        
87         # Interval between attempts to check the hash, in milliseconds.
88         #hash_interval = 100
89        
90         # Number of attempts to check the hash while using the mincore status,
91         # before forcing. Overworked systems might need lower values to get a
92         # decent hash checking rate.
93         #hash_max_tries = 10
94        
95         # Max number of files to keep open simultaniously.
96         #max_open_files = 128
97        
98         # Number of sockets to simultaneously keep open.
99         #max_open_sockets = <no default>
100        
101        
102         # Example of scheduling commands: Switch between two ip's every 5
103         # seconds.
104         #schedule = "ip_tick1,5,10,ip=torretta"
105         #schedule = "ip_tick2,10,10,ip=lampedusa"
106        
107         # Remove a scheduled event.
108         #schedule_remove = "ip_tick1"[/PHP]

其中有些参数不是很清楚,应该如何设置,虽然对付能翻译过来但不理解其含义..
行号如下,希望能有人帮助!
10
11
34
40
43
44
48
49
104
105